Tensile testing machine wholesale today? Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. Discover more info on textile testing machines.
Fabric color fastness to light machine Feature: The 2500W long arc xenon lamp is used to simulate the solar spectrum. High transmittance of filter combinations and use 95% of the transmittance filters and filter cartridges. With Low power consumption but achieve the same irradiation light requirements. To make the machine is more energy saving and environment friendly. Standard equipped with 420nm wave band, irradiance digital setting, real time monitoring, closed loop automatic regulation, providing the most stable irradiance test light source for different standards (340nm, 420nm, 300-400nm and 300-800nm band optional ). Test and radio transmission are powered by using light conversion technology, no additional power supply is required. With industrial temperature control (refrigeration) system for smoothly and fast adjusting temperature in test chamber.
Correct use of computerized universal testing machine: When opening the clamp to take the sample, pay attention to the clamping distance of the sample, not too much or too little. When the tensile testing machine and the microcomputer are connected, the operation must be carried out according to the program requirements. It is strictly forbidden to operate the program due to illegal operation; The parameters to be printed check whether the printer has paper and replenish it in time before printing. After the operation is completed, shut down the tensile testing machine for rubber according to the program requirements. It is strictly forbidden to cut off the power directly.
The AC servo drive system with low noise and wide range of applications. Pneumatic Bursting Strength Tester Test Methods: Constant Time Bursting. The tester bring saving and printing functions and support on-line operation. Provide on-line interfaces, professional detection software which can be used to analysis testing result. Summary of Test Method: A specimen is clamped over an expandable diaphragm. The diaphragm is expanded by fluid pressure to the point of specimen rupture. The difference between the total pressure required to rupture the specimen and the pressure required to inflate the diaphragm is reported as the bursting strength.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test. See extra info at https://www.gesterinstruments.com/.
Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.
